|
LUBRICATING
OIL HEATER WITH THERMOSTAT
PART NO. S-13A FOR SENTRY-PRO 7 THRU
12.5 KW, GEN-SETS WITH AIR COOLED ENGINES.
|
|
|
Lubricating oil heater
with lubricating oil thermostat and 1" NPT threads. Used on
small air cooled engines, for faster engine starts during the cold
winter, by circulating warm oil into the cold engine.
- S-13A:
75 Watt, 120 VAC, 1.6 Amp, lube oil heater.
- The lub oil heater is a 75 Watt,
120 VAC cartridge heater.
- The lub oil thermostat regulates
oil temperature to 60°F (ON), 80°F (OFF).
- The thermostat prevents the
possibility of overheating lub oil, thus degrading or damaging the
lub oil.
- Factory installed only.
|
|
|
|
INDUSTRIAL
TANK / CIRCULATION ENGINE WATER HEATER
PART NO. S-13B FOR
SENTRY-PRO 15 THRU 45 KW GEN-SETS WITH LIQUID COOLED ENGINES
PART NO. S-13C FOR
SENTRY-PRO 60 THRU 130 KW GEN-SETS WITH LIQUID COOLED ENGINES |
|
|
Industrial
tank/circulation engine heater offers dependable engine starts in all
temperatures. By circulating warmed coolant through an engine, it assures
a quick start, reduces time to reach operating speed and enhances
immediate full-load acceptance.
- S-13B:
750 Watt, 120 VAC, 6.3 Amps (3305032) engine water heater with
thermostat for 15 thru 45 KW generator sets, mounted and plumbed to
engine.
- S-13C:
1000 Watt, 120 VAC, 8.3 Amps (3305044) engine water heater with
thermostat for 60 thru 130 KW generator sets, mounted and plumbed to
engine.
- Rugged die cast aluminum
construction is corrosive and impact resistant.
- Low watt density copper heating
element provides optimum performance.
- Temperature sensing thermostat
provides over heat protection in regulated heat range of 80°F (ON),
100°F (OFF).
- Temperature and oil resistant with permanently
connected 5 ft. cord and grounded male plug.
- Factory installed only.
|
Previous
Gillette Generators, Inc.
Copyright © 2004 All rights reserved.
|
